Die Celestron StarSense Explorer LT 70AZ als Geburtstagsgeschenk zu erhalten, war ein aufregender Moment, und nach dem Zusammenbau wartete ich gespannt auf einen klaren Abend. Als die Wolken endlich auseinanderzogen, sah ich Saturn und wusste, dass es Zeit für meine erste Beobachtung war. Das Teleskop enthielt Okulare mit 10 mm und 25 mm sowie eine 2x Barlow-Linse. Anfangs übersprang ich das Einstellen des Smartphone-Okulars, da ich dachte, es sei nicht notwendig, aber alles, was ich sah, war schwarz. Nachdem ich es korrekt ausgerichtet hatte, war ich begeistert, Saturn als hellen Ball zu sehen – sogar ohne seine Ringe – mit dem 25-mm-Okular.
Als nächstes probierte ich das 10-mm-Okular aus, das nicht viel zeigte, und versuchte dann, das 25-mm-Okular mit der Barlow-Linse zu kombinieren, mit der Erwartung von 50-facher Vergrößerung. Doch egal, wie ich es einstellte, konnte ich nichts sehen, nicht einmal das ferne Objekt, das ich zur Ausrichtung verwendet hatte. Ich bin neugierig, wie man die Barlow-Linse richtig verwendet und ob es tatsächlich schwieriger ist. Wäre es sinnvoll, in ein Okular mit höherer Vergrößerung zu investieren, oder wäre es unwahrscheinlich hilfreich? Außerdem würde ich gerne Tipps zum Verhindern von Wechseln der Kameraobjektive bei der Fotografie durch das Okular zu schätzen wissen, sowie weitere Tipps für Anfänger.
When you change eyepieces, the object or telescope may shift slightly, requiring you to reposition it. The object won’t be far off. Like any new hobby, it takes time to develop proficiency. Patience is key. Good luck and enjoy!
The numbers on the eyepieces indicate their focal length, not the magnification. To calculate magnification, divide the telescope’s focal length by the eyepiece’s focal length. A lower number on the eyepiece means higher magnification. Have you tried focusing the telescope? I recommend starting by reading the full instructions.
Align the StarSense phone app with your telescope during the daytime. Choose a distant object, such as a tower top, chimney, or treetop about a mile away. Center it in your eyepiece, then align the app without moving the telescope. The app will guide you through the process. Even after alignment, there may be a slight discrepancy between the app and the eyepiece view. Adjust the telescope slightly up, down, left, or right to fine-tune it.
Are you using the focus knob to refocus the scope? When you change eyepieces, you need to refocus the telescope. Out-of-focus bright stars appear as blurry balls, but stars should be sharp dots. As you approach focus, dimmer stars will start to appear. I consider the focus correct when stars are sharp and adjusting in either direction doesn’t reveal any dimmer stars.
The 10mm eyepiece (not 10x) will provide a better view. In these kits, the Barlow lens is often the lowest quality component. Starting with the 25mm was the right approach, as it offers a magnification of 28x and the widest field of view. The 10mm eyepiece gives 70x, which is suitable for viewing Saturn. Your telescope’s maximum magnification is about 140x, or twice the aperture. If the Barlow lens is decent, you can use it with the 10mm eyepiece to reach 140x, but the field of view will be narrow, and objects will move out of view quickly. Properly aligning the finder is crucial, especially at higher magnifications.