تلقّيت تلسكوب Celestron StarSense Explorer LT 70AZ كهدية لعيد ميلادي، وكان ذلك لحظة مثيرة، وبعد تركيبه، انتظرت بحماس ليلة صافية. عندما انفتحت السحب أخيرًا، رأيت زحل وعلمت أن الوقت قد حان لمعاينتي الأولى. جاء التلسكوب مع عدسات 10 مم و25 مم ومرآة تكبير 2x. في البداية، تجاهلت تعديل منظار الهاتف، ظنًا مني أنه غير ضروري، ولكن ما رأيته فقط كان أسود. بعد العودة والتوافق بشكل صحيح، كنت سعيدًا جدًا برؤية زحل ككرة مضيئة - حتى بدون حلقاته - باستخدام عدسة 25 مم.
ثم قمت بتجربة عدسة 10 مم، والتي لم تكشف عن الكثير، ثم حاولت دمج عدسة 25 مم مع مرآة التكبير، متوقعًا تكبيرًا بقوة 50x. ومع ذلك، لا يهم كيف قمت بالتعديل، لم أتمكن من رؤية أي شيء، حتى الكائن البعيد الذي استخدمته للتوافق. أود معرفة الطريقة الصحيحة لاستخدام مرآة التكبير وهل من الصعب حقًا. هل يستحق الاستثمار في عدسة ذات تكبير أعلى، أم أن هذا من غير المرجح أن يساعد؟ بالإضافة إلى ذلك، أود الحصول على نصائح حول منع هاتفي من تغيير العدسات عند محاولة التقاط صورة من خلال العدسة، وكذلك أي نصائح للمبتدئين الأخرى.
When you change eyepieces, the object or telescope may shift slightly, requiring you to reposition it. The object won’t be far off. Like any new hobby, it takes time to develop proficiency. Patience is key. Good luck and enjoy!
The numbers on the eyepieces indicate their focal length, not the magnification. To calculate magnification, divide the telescope’s focal length by the eyepiece’s focal length. A lower number on the eyepiece means higher magnification. Have you tried focusing the telescope? I recommend starting by reading the full instructions.
Align the StarSense phone app with your telescope during the daytime. Choose a distant object, such as a tower top, chimney, or treetop about a mile away. Center it in your eyepiece, then align the app without moving the telescope. The app will guide you through the process. Even after alignment, there may be a slight discrepancy between the app and the eyepiece view. Adjust the telescope slightly up, down, left, or right to fine-tune it.
Are you using the focus knob to refocus the scope? When you change eyepieces, you need to refocus the telescope. Out-of-focus bright stars appear as blurry balls, but stars should be sharp dots. As you approach focus, dimmer stars will start to appear. I consider the focus correct when stars are sharp and adjusting in either direction doesn’t reveal any dimmer stars.
The 10mm eyepiece (not 10x) will provide a better view. In these kits, the Barlow lens is often the lowest quality component. Starting with the 25mm was the right approach, as it offers a magnification of 28x and the widest field of view. The 10mm eyepiece gives 70x, which is suitable for viewing Saturn. Your telescope’s maximum magnification is about 140x, or twice the aperture. If the Barlow lens is decent, you can use it with the 10mm eyepiece to reach 140x, but the field of view will be narrow, and objects will move out of view quickly. Properly aligning the finder is crucial, especially at higher magnifications.